While these vinyled windows may not be quite the trend they were a couple of years ago, they still look amazing with the ever popular farmhouse decor.
For my two most recent vintage window projects, I chose windows that have 6 panes, but any old window with a wooden sash will do. Please keep in mind that many old windows have lead paint. Because of this, you will want to take care of anything that might be chipping off. Sometimes I am able to leave the windows as I find them, and other times they need a bit of work.
The sash for my sailboat window didn’t really have any paint left on it, and I liked it just as it was. Hubby did spray the wood for me with a clear lacquer, just to make it a little easier to keep clean. However, you really wouldn’t have to even do that.
When using windows with several panes, it is easiest to divide your design before you cut it. I prefer to draw up the window in my design software before I do any cutting. By doing this, I am able to lay the image out so that I know exactly where the muntins (the pieces of wood that divide the panes of glass) will cross my design. That way, I can put cut lines there, making the large vinyl design easier to manage and lay out on the window after cutting.
- Vintage window with wooden sash
- Intermediate Vinyl
- Clear Transfer Tape
- Small squeegee
- Xacto Knife
- Glass cleaning supplies, including razor blade if needed.
- Tools, paint, glass putty, etc. as needed to clean and refurbish sash.
- Red Capped Blade
- Large Self Healing Cutting Mat with Grid
Settings for Zing Orbit and MTC:
- Force – 23
- Speed – 10
- Multicut – 1
- Clean and refurbish sash of window as needed.
- Clean glass. Use a razor blade to clean up any old paint drips, etc. from glass.
- If needed, lay out design on drawing of window as shown above. This will not be necessary in all cases. Put cut lines where required in design.
- Cut and weed design. Apply transfer tape.
- If you have a large self-healing cutting mat, it is useful to lay that out on your work table and place your window on top of it. This way you can use the lines of the mat to line up your design as you place it on the window. (Just make sure you have the window aligned carefully with the line of the mat before you begin laying out your vinyl.)
- Place your vinyl carefully on the glass. In some cases, you might have vinyl that comes up to an inside corner of crossed muntins. (In the case of the sailboat design, you’ll see that I did not have this issue, as the design did not cross any corners. You may want to consider this issue when you choose your design.) If so, work your vinyl carefully into the corner and up the wooden muntins.
- You may need to slice the vinyl from the outside corner in slightly to be able to work the vinyl into the corner. Use your squeegee to get any air bubbles out, working from the middle of the vinyl outward. Snug vinyl up to muntin and use an xacto knife and straight edge to careful trim any vinyl at the edge of the muntin.
- Continue in this way until your design is complete.
- Now, display your vintage window work of art for all to admire!