I have done etching on glass a few times, but wanted to see how it would work on ceramic. A few of these cute little ceramic jars have been sitting in my craft room since I found them on clearance a few years ago. The nice smooth surface provided just the canvas I needed to try out this project.
- Ceramic Jar
- Armour Etch Cream
- Gilders Paste Wax
- Vinyl for Stencil
- Transfer Tape
- Paint Brush
- Protective clothing, such as rubber gloves, goggles, apron
- Red Capped Blade
Setting for KNK Zing:
- Force – 18
- Speed – 10
- Multicut – 1
- Open or download design in cutter software.
- Load vinyl and cut stencil.
- Weed vinyl stencil.
- Apply transfer tape to vinyl, remove backing, and apply stencil to ceramic surface.
- Remove transfer tape.
- Use paint brush to apply etching cream liberally, being careful not to extend the cream beyond the edge of your stencil.
- Leave the cream on a few minutes. I left mine on about 3 minutes.
- Clean off thoroughly under running water.
- Peel off stencil and dry completely.the
- Use a rag to apply Gilders Wax to etched surface. Continue rubbing to remove from non-etched area. (The wax sets quickly, so I had best luck by removing excess wax as soon as possible. It can be removed later, but takes a lot more effort.)
I realized after I started the project that it was not a good idea to plan a two-color project where the two colors were directly adjacent to each other. It was very difficult to apply the end of the “green” stem within the red cherry portion of the design,
I also attempted this on a ceramic tile. It worked, but I wasn’t happy with the end result. The entire tile apparently was a little porous as I was not able to completely remove the excess wax from the surface of the tile. This might be remedied by leaving the stencil in place while applying the Gilders Wax. I may have to give it another try.